Buy - Along Clamps

RFQ Details

"Modern micro chip adopted which makes it alarm on time, high accuracy and reliability,
flexible volume and easy installation. It features power saved, low battery warning,
non-false alarm. Widely used for rolling door, shutter door, garage door.
Specification:
1. Triggered distance :< 6 cm
2. Working voltage12V DC, with dry battery model:23A
3. Working currentd10mA; Static currentd5�A
4. Working frequency433.92 MHZ�2KHZ or 315 MHZ
5. Transmitting distancenoninterference e200m ; indoor about 30~50 m
6. Emitting frequency>10mw
7. Operating temperature: indoor -10 ~ 50, related humidity d 95%
8. Power: standby :0.01W, Alarm :0.09W
9. Size: Transmitter part: 90 mm(L)�55 mm(W)�22 mm(H);Metal magnetic part:
60mm(L)�15mm(L)�13mm(H) . Weight: 0.6
Installation:
1. Code preset by factory. If not, please follow the following code diagram to play it by
clamp
2.Metalized magnetic part: It should be installed in the motion door and keep it parallel
with the side of the base.
3.Metalized reed pipe: It should be installed on the floor by screws, and keep it at the
same level and parallel with the metalized magnetic part, the distance between two
parts no more than 2cm.
4.Wireless emitting sensor: There is a wire connected with the metalized reed pipe, and
must keep within the receiving area, the signal wire should be installed along the floor.
For example, if you are on the 8th floor, but your garage is on the first floor. You can
install the wireless emitting sensor in your home, and extend the wire into the garage.
5. Open the cover of transmitter, fix battery in proper and than cover it.
6. Test it: put two metalized parts close and than open it. If the signal LED flashes, it
means normal work.
7. After installation, open the door, the signal LED flashes about one second, it means
installing completed
8. Stick sticker paper on the rear of transmitter and stick it on the wall, even pin it up by
screw.
9. if Green low battery LED turns on, it means battery voltag